Max Power VIP 150 HYD hydraulic retractable thruster

The VIP 150 HYD is a vertically retracting hydraulic thruster for bow or stern installations where the hull design and hydraulic system allow it. It deploys for low-speed maneuvering and retracts flush with the hull when not in use. Choose the 12V or 24V control voltage to match the yacht’s electrical system. In both versions, thrust is supplied by the hydraulic drive. These are control options for the same hydraulic VIP 150 HYD model, not two different thrust ratings.

Choose the control voltage

Identify the voltage of the vessel’s control circuit before ordering. The 12V configuration has manufacturer code 317702; the 24V configuration has code 317703. Select the corresponding variation above so the correct electronics are supplied with the hydraulic thruster.

Specification 12V control 24V control
Manufacturer code / SKU 317702 317703
Control voltage 12V 24V
Hydraulic drive VIP 150 HYD VIP 150 HYD

Technical specifications

  • Model: VIP 150 HYD hydraulic retractable thruster.
  • Maximum published thrust: 120 kgf / 264 lb.
  • Hydraulic power: 10 kW; dual propellers.
  • Tunnel diameter: 185 mm; unit weight: 28 kg (manufacturer specification).
  • Manufacturer dimensions A–F: 290 / 290 / 580 / 185 / 810 / 240 mm.

The 28 kg figure is the manufacturer-stated unit weight. YachtAid’s existing product records use 120 lb as the shipping weight for both control versions; shipping weight is retained per variation and should not be confused with unit weight.

Vessel fit and performance conditions

The manufacturer’s selection guide places the VIP 150 HYD in different vessel length ranges according to displacement and windage:

  • Heavy displacement, high windage or cruising boats: approximately 40–50 ft / 12–15 m.
  • Medium displacement, medium windage or fast cruising boats: approximately 45–55 ft / 14–17 m.
  • Light displacement, light windage or very fast cruising boats: approximately 48–60 ft / 14.5–18 m.

These ranges are selection guidance, not a substitute for engineering review. Published performance assumes immersion depth equal to one tunnel diameter and a tunnel no longer than twice its diameter, with a stated variation of approximately ±6%. Longer tunnels can reduce thrust and increase power consumption. Confirm hydraulic flow, pressure, hull geometry, immersion and mounting requirements with the installer before ordering.

Included equipment and installation

The manufacturer data sheet lists a black joystick, control box, directional power control relay and 25 m control cable with the VIP 150 HYD. The mounting base and other accessories must be ordered separately. The retracting arrangement is designed to leave smooth hull lines when stowed and reach the intended immersion depth when deployed. A separate mounting base supports installation planning; the manufacturer lists GRP and aluminium base options.

Max Power’s control system documentation also lists childproof activation, shutdown after 30 minutes of inactivity, overheat warning and shutdown, automatic battery isolator control, delay between port and starboard thrust, and short-circuit protection. Confirm the exact supplied controls and compatible accessories for the selected 12V or 24V version.

Documentation

VIP 150 HYD product data sheet · Installation manual · Technical drawing

Weight 120 lbs
Dimensions 30 × 35 × 30 in
Power Supply

12V, 24V

Reviews

There are no reviews yet.

Only logged in customers who have purchased this product may leave a review.