3/8″ LED Rope Lighting, 12V Red

3/8″ LED Rope Lighting, 12V, Red, Length: 1 ft.

LED Rope Lighting is sold by the linear foot.  The following required parts must be purchased separately to complete your rope light installation:

For 12VDC:

• ILMDL-CONKIT-6, Connector Kit for 3/8″ Incandescent or DC-Powered LED Rope Light (Connector, & 6′ Cord)
• ILMDL-END, End Cap

For 12VAC:

• ILMDL-CON12V-L6, Connector Kit for 3/8″ 12VAC LED Rope Light when using Transformer (Connector, Rectifier & 6′ Cord)
• ILMDL-END, End Cap

Recommended Item:

Power Conditioner, regulates optimum output voltage for use with LED rope light.

Check our Knowledge Base for information on using dimmers with LED Rope Light.

Special note for household use:

• Our 120V LED rope light with 120V connection kit (ILMDL-CONKIT-L6) may be plugged into any standard commercial or residential wall outlet without the need for an AC adapter or transformer. If hard-wiring, simply cut off the existing plug from the power cord and prepare (strip) the cable ends. Please note that there is no ground wire.

• Our low voltage (12V or 24V) LED rope light may also be used for residential/commercial use as well. However it will not be supplied with an AC adapter or other means for stepping the voltage down as that must be ordered separately. Please visit our “Lighting Accessories” page for a selection of both AC transformers and AC to DC LED converters. The type of connector kit is dependent on the type of voltage converter being used. If using a traditional step down AC transformer, be sure to use one of the following connection kits: (ILMDL-CON12V-L6 for 12VAC input; ILMDL-CON24V-L6 for 24VAC input). If using a voltage-regulated LED converter, then you should use the ILMDL-CONKIT-6 for either 12VDC input or 24VDC input.

Specifications: